Roberts 10-35 Manuel d'utilisation et d'entretien télécharger pdf (Page 2)

WARNING

• Always wear safety glasses when operating this tool

• Keep cutting blade in the fully closed position when not in use

• Keep fingers and hands away from blade cutting area

• Periodically check that all hardware remains tight

1. Assemble handle (G) to the cutting blade (2) with the provided screws (H),

washers (F) and locknuts (E) as shown in the parts diagram.

2. Assemble the blade (2) to the cutter base (I) using the two nylon spacers (1 and 3)

and double threaded shaft (D) as shown in the parts diagram.

1. Place cutter on the floor making sure it is on a level surface.

2. Mark the work piece to be cut and insert it against the

backstop. The “V”-Support (L) should be used to support

the laminate while cutting.

3. Always cut laminate with the finished side up. Place the

grooved or indented side of the laminate against the

backstop. (The "tongue" side should be closest to the

blade.) Begin the cut by holding the laminate firmly with

one hand and cutting into the laminate with the blade

approximately 1/2 in. You now have started your cut.

Proceed using both hands with a smooth powerful

downward motion to complete your cut.

4. Remember the cut side will always be placed along the wall to

be covered up by baseboard or finish molding.

• Keep cutter clean and store in a dry place when not in use

• Keep edges of blade sharp by using a sharpening stone

• Periodically check all assembly to ensure that hardware remains tight

SAFETY WARNINGS FOR 10-35 LAMINATE CUTTER

OPERATING INSTRUCTIONS

MAINTENANCE

ASSEMBLY INSTRUCTIONS FOR 10-35

LAMINATE CUTTER

Owners Manual-TRI 10_35-new model.qxd:Owners Manual 10_35.qxd 9/26/08 1:48 PM Page 2

1 2 3 4 5 6 7 8

Pas de commentaire

Roberts 10-35 Manuel d'utilisation et d'entretien Page 2